D+ MASTER WALL PUTTY is a white cement-based fine powder used as a filler and leveller for walls and ceilings. It provides a waterproof surface with excellent smoothness, good adhesion and good breathing properties. The putty seals surface porosity to support uniform deposition of finished paint and enhances durability.

It is a water-resistant, white cement-based putty suitable for concrete and mortar walls and ceilings. It fills the fine pores of mortar and concrete surfaces and provides a white, smooth and dry surface suitable for painting. The product can be used for both interior and exterior surfaces.

Advantages

• Suitable for both interior and exterior surfaces.
• Does not require curing.
• Provides a smooth and glossy finish.
• Any kind of paint or distemper can be applied over it.
• Provides better adhesiveness and durability as a cementitious material.
• Can be applied on used surfaces after proper preparation.
• Dry powder form with no unpleasant smell during application.
• Water resistant.
• Can be applied on moist surfaces.
• Helps prevent growth of algae and fungi on walls.
• No primer is required before application of paint or distemper.

Application

D+ MASTER WALL PUTTY is suitable for:

• Walls
• Ceilings
• Concrete walls
• Mortar walls
• Internal surfaces
• External surfaces
• Rendered walls
• Hollow block surfaces
• Precast walls
• Concrete ceilings
• Calcium silicate bricks

Surface Preparation

The surface should be clean and free from dirt, oil, grease and loose sand particles. Dry and absorbent surfaces should be moistened with clean water before application. Old painted or lime-washed surfaces should first be scratched.

For old unpainted surfaces, loose material, organic growth, dirt and dust should be removed using a steel blade or wire brush. For old painted surfaces, the surface should be scrubbed with a coarse wire brush or sandpaper until the cementitious/plastered surface is visible.

For very rough surfaces, white cement or white cement mortar should first be used to level the surface, followed by curing for 2 days. Very smooth surfaces should be scraped with emery stone/paper to improve bonding.